DMS AS/400 - Display Messages

AS/400 User Guide
Back to Instructions
Back to Top
Display Messages
Steps:
1. Type "DSPMSG" on the command line and press the F4 (PROMPT) key
or ENTER key
OR
• From Main Menu, select Option 3
• From General System Tasks, select Option 4
• From Messages, select Option 2
2. To display messages enter one of the following options on the message queue line:
• WRKUSR - display messages sent to the workstation message queue if any
exist. After exiting messages sent to the user profile message queue are
displayed.
• WRKSTN - display messages sent to the workstation message queue.
• SYSOPR - display messages sent to the system operator message queue.
• USRPRF - display messages sent to the user profile message queue.
DMS Systems Corp. 33
October 13, 2003
Version 1.0