Dormakaba ED900 - Page 41

41
ED900 09-2021DL4617-001
dormakaba ED900 Setup and Troubleshooting Instructions Appendix A
Parameter
Value
range
Units
Factory
setting
Description
Push & Go.

 -  
 Off

. Parameter is activated.
. Automatic opening of door is started when door is manually moved ° out of the
closed position.
. Door close mode parameter hd must be set to "" (automatic) to enable this
function.
Mode switch type.

 -  
 Internal, operator mounted Mode switch is active.

External mechanical Mode switch with contacts is connected to operator terminal
board. Internal Mode switch connector must be removed.

External DCW electronic Mode switch (EPS) is connected to operator terminal
board. Internal Mode switch connector must be removed.
 Program switch control by TMS Soft control software.

. DCW electronic Mode switch (EPS) is installed, and operator is also connected
by the building management system to TMS Soft control software.
. When PS is set to , the Mode switch functions can be changed from
DCW (EPS) to TMS Soft..
Not used.

 -  

Not used.

Internal Mode switch, switch on delay.

 -  

Operator will perform function of new switch setting as soon as internal Mode
switch is moved.

. Operator will perform function of new switch setting after a delay of  seconds
from when internal Mode switch is moved.
. This function is useful if user has to pass through door and its connected
detectors and sensors after Mode switch is set to new function.
Unlocking during business hours.

 -  
 Door is always locked when it reaches closed position.

. In automatic mode, door will not lock when it reaches closed position. This
achieves faster door opening when system is equipped with motor driven locks.
. If an electric strike opener is used, it must be suitable for % continuous duty
factor to avoid possibility of damage.
A. Driving parameters detail.