5.12
EJECTOR SHOE ADJUSTMENT
If the ejector panel has excessive side to side movement and is binding or stalling in the body, it
may be caused by the ejector shoes not being properly adjusted.
Washers (Part no. FS055-1119-001) are installed behind the wear shoes (see figure below). The
clearance between the shoe and track should never exceed 1/4”. The tighter the clearance, the
less chance the ejector panel will turn and bind in the body.
Printed in U.S.A.
©COPYRIGHT 2006, Heil Environmental
ISSUED JANUARY 2006
To Next Page
