Program 109-0201 Rear Loader Pack On The Fly
109-0201.doc Revision - 12/19/08
Page 3 of 3
Note: The PLC is placed in calibration mode by jumping a +12 volt signal to input 0.01 and 0.02. After 10
seconds the R-stator signal is stored into the PLC memory and used to calculate engine speed. The engine speed
must be held at 1000 rpms for 10 seconds. Output 10.06 will be on after the 10 seconds have elapsed and will
remain on until the power on inputs 0.01 or 0.02 is removed.
To Next Page