6.2
SPECIFICATIONS
Hydraulic Cylinders:
Blade (lower panel) .......................................................................................................... 5-1/2” Bore x 24” Stroke
Upper Panel .............................................................................................................................5” Bore x 36” Stroke
Tailgate Raise................................................................................................................... 4” Bore x 24-1/2” Stroke
Container Arm .................................................................................................................3” Bore x 18-7/16” Stroke
Roll Bar....................................................................................................................... 2-1/2” Bore x 14-1/2” Stroke
Reeving ...................................................................................................................... 5-1/2” Bore x 49-3/4” Stroke
Tailgate Valve:
Blade (Lower Panel) Detent ...................................................................................................................... 2400 PSI
Blade Back-Off Relief ................................................................................................................................ 3900 PSI
Optional Mechanism (Winch, Roll Bar)..................................................................................................... 1400 PSI
Tailgate Valve:
Blade (Lower Panel) Detent ............................................................................................................2400 +/-50 PSI
Blade Back-Off Relief ......................................................................................................................3900 +/-50 PSI
Optional Mechanism (Winch, Roll Bar)...........................................................................................1400 +/-50 PSI
Packer Mechanism Cycle Times (Empty Hopper);
Complete Cycle – PTO Direct Mount without Driveline@ 27 GPM........................................... *28 to 32 Seconds
Complete Cycle – Std. Front Mount or PTO Mount with Driveline@ 47 GPM............................ 16 to 18 Seconds
Reload - PTO Direct Mount without Driveline@ 27 GPM.............................................................. 9 to 11 Seconds
Reload – Std. Front Mount or PTO Mount with Driveline@ 47 GPM .............................................. 6 to 7 Seconds
Tailgate Cycle times;
Raise .................................................................................................................................................... 20 Seconds
Lower (use engine low idle only) ......................................................................................................... 21 Seconds
Hopper Capacity.......................................................................................................................................3.1 Cu. Yd.
.
* It is acceptable to set the cycle time between 22-32 seconds when certain engine/PTO combinations prohibit
meeting the 28 second minimum.
ISSUED FEBRUARY 2006
Printed in U.S.A.
To Next Page
Loading...