Preparing for use
18
Fitting components
Preparing for use
The following instructions cover:
— Assembly of the various equipment items.
— Electrical connection and gas connection.
— Setting the language for display texts.
— Automatic device check with calibration of the sensors.
Fitting components
● Always use properly prepared parts, see "Care", page 90.
Fitting the expiration valve
● Push the expiration valve block firmly into the mounting.
Check that it is properly secured by gently pulling the port.
Fitting the flow sensor
1 Push the socket to the left as far as it will go.
2 Insert the flow sensor – with the probe facing towards the
ventilator – into the mounting and push it into the socket as
far as it will go.
Then:
3 Push flow sensor to the right as far as it will go into the
rubber lip of the expiration valve.
052053
1
054
2
3
To Next Page
Loading...
