EasyManuals Logo

Dräger P3U User Manual

Dräger P3U
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
107
Metrological certificate of approval
Information on DrägerSensor O
2
-LS (6809630)
Cross sensitivities
The table shows the reactions of the sensor to other gases than the measured gas (cross sensitivities). The listed values are typ-
ical and are valid for new sensors. The table does not lay a claim on completeness. Gas mixtures can be displayed as the sum of
all components. Gases with negative sensitivity can cancel out a positive sensor display. The influence of the O
2
displacement is
in not taken into account in the table.
Example:
With 2 Vol.-% ethylene in the air – measurement value deviation due to cross sensitivities (table value) = –1 Vol.-% O
2
O
2
dis-
placement caused by 2 Vol.-% ethylene (2% of 20 Vol.-% O
2
) = –0.4 Vol.-% O
2
Polytron transmitter display (20.9 – 1 – 0.4) = 19.5 Vol.-% O
2
.
Principle of measurement: The DrägerSensor O
2
-LS (6809630) is an electrochemical three-electrode-sensor for measurement of oxygen
(O
2
) in air. The sensor can only be operated in connection with a suitable Dräger transmitter. The sensor cannot
be used for oxygen measurements in the presence of helium!
Reaction at the measuring electrode: O
2
+ 4 H
+
+ 4 e
=> 2 H
2
O
Reaction at the counter-electrode: 2 H
2
O => O
2
+ 4 H
+
+ 4 e
Ambient conditions:
Operational Characteristics -40
o
C to 60
o
C, short-term up to 65
o
C
700 hPa to 1300 hPa
5 to 95 % relative humidity, non condensing
storage (in original packaging) 0
o
C to 40
o
C
Measured value time setting:
t
0...20
: <12 seconds
t
0...90
<30 seconds
Calibration:
Flow rate: 0.5 L/min
Zero gas Nitrogen (99.9 Vol.-% N
2
)
Calibration gas Oxygen / nitrogen - mixed gas
Warming-up time:
Sensor is ready to operate after 90 minutes
Sensor is ready to calibrate after 6 hours
Gas / vapour Chemical symbol Gas concentration Measurement value deviation in Vol.-%
with dust filter
acetaldehyde CH
3
CHO 50 ppm no influence
acrylonitrile H
2
C=CH–CN 80 ppm no influence
ammonia NH
3
50 ppm no influence
arseniuretted hydrogen AsH
3
3 ppm no influence
butadiene CH
2
CHCHCH
2
50 ppm no influence
tert-butylmercaptane (CH
3
)
3
CSH 4 ppm no influence
chlorine Cl
2
8 ppm no influence
hydrogen chloride HCl 20 ppm no influence
hydrocyanic acid HCN 20 ppm no influence
boroethane B
2
H
6
5 ppm no influence
1.1-dichloroethane C
2
H
4
Cl
2
50 ppm no influence
diethylamine (C
2
H
5
)
2
NH 100 ppm no influence
diethyl ether (C
2
H
5
)
2
O 400 ppm 0.1 (–) *
epichlorhydrine C
2
H
3
OCH
2
Cl 35 ppm no influence
ethanol C
2
H
5
OH 250 ppm no influence
ethylene C
2
H
4
2 Vol.-% 1 (–) *

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dräger P3U and is the answer not in the manual?

Dräger P3U Specifications

General IconGeneral
BrandDräger
ModelP3U
CategoryTransmitter
LanguageEnglish

Related product manuals