Installing accessories
30
3 Bend the snap-hooks on the cover of the measuring unit slightly outwards to re-
lease them.
4 Remove the cover.
5 Hold the dongle with the "Dräger" logo pointing towards the measuring unit. Then
insert the dongle into any of the three slots.
Up to three dongles may be installed simultaneously.
● Place the cover on the measuring unit and press it down until it snaps into posi-
tion.
7 Slide the measuring unit into the docking station and lower it into position, see
page 24.
8 Turn the eccentric catches clockwise with an Allen key to lock the measuring unit
(
⇒ = approx. 180
o
).
6 Attention:
Take care that pressure is applied only to the sleeve (6) of measuring unit.
Pressure on the inner structure can damage the unit.
Note:
Correct operation of the software dongle can be checked by switching
the measuring unit on and selecting the menu items » Information «,
» Instrument «, » Module « from the unit menu, see page 53.
02623758_1.eps
Polytron
OK
3
4
3
02723758_1.eps
5
6
55
02823758_1.eps
7
8
To Next Page
Loading...
