67
The menu » Settings «
Function key
— This function is used to set the function which is to be activated when the function
key (the » « key) is pressed briefly.
Default setting: Fault report.
● Select the menu items » Settings «, » Instrument « and » Function key « in this or-
der, pressing the » « key after each selection.
● Select the desired function and press the » « key to activate. An icon corre-
sponding to the selected function appear on the right side of the display. Possible
selections:
— In measuring mode, briefly pressing the » « key will now activate the
selected function.
Initialise device
This function resets all parameters of the transmitter to the factory default settings.
This affects the following parameters:
It also affects the setting parameters for:
● Select the menu items » Settings «, » Instrument « and » Device init. « in this order,
pressing the » « key after each selection.
● Select » Confirm « and press the » « key to initialise the device.
Show graph – the measured values are displayed on a time axis,
see page 55
Fault report – existing faults are displayed in clear text, see page 53
Notice
report
– existing warnings are displayed in clear text, see page 53
Fault codes – existing fault codes are displayed in a numerical table,
see page 53
— Sensor lock.
— Gas selection (if the sensor is suitable for measuring several different gases).
— Units in the measured value display (normally ppm).
— Measuring range for the 4 to 20 mA interface.
— Gas configuration of the calibration gas (if the sensor is suitable for calibration
with a replacement gas).
— Calibration interval The sensor-specific default values can be found in the related
sensor data sheet.
— Pump output
— Alarm parameters
— Passwords
— Language
— Function key
— HART interface
— Datalogger
— Analogue interface
OK
OK
OK
OK
To Next Page
Loading...
