Drobo 5D3 - Blinking Lights to Test Connectivity

Drobo 5D3 User Guide 74
5. Your Drobo device gets reset to its factory settings, which can take a few minutes.
Once complete, this Drobo device will no longer appear in the Drobo Dashboard.
Note:
If the Drobo device remains powered on and connected to your host computer, the
Drobo Dashboard will re-discover the Drobo device as if it were new.
5.6 Blinking Lights to Test Connectivity
A simple test to verify that your Drobo 5D3 is connected, directly or indirectly, to your
host computer, is to use Drobo Dashboard to blink the lights on your Drobo device.
To make the lights blink:
1. From the All Drobos page, select the Drobo device whose connectivity you would
like to check.
2. Click the Tools option on the Navigation menu. The Tools page for that Drobo device
opens.