Front Panel Configuration
Page 77 of 90 057-233 ISSUE: 1
Press and hold the Stop and Tick buttons simultaneously to
enter the editor.
If a module security PIN has been set, the PIN number request is then
shown :
Editor
Press the Tick
button, the first ‘#’ changes to ‘0’. Press (up or down) to adjust it to the correct
value.
Press (right) when the first digit is correctly entered. The digit entered is now shown as ‘#’ for
security.
Repeat this process for the other digits of the PIN number. Press (left) to move back and adjust
one of the previous digits.
When the Tick
button is pressed after editing the final PIN digit, the PIN is checked for validity. If the
number is not correct, re-enter the PIN.
If the PIN has been successfully entered (or the module PIN has not
been enabled), the editor is displayed :
Editor - Display
NOTE: The PIN number is not set by DSE when the module leaves the factory. If the
module has a PIN code set, this has been affected by the ATS supplier who must be contacted
if the code is required. If the code has been ‘lost’ or ‘forgotten’, the module must be returned
to the DSE factory to have the module’s code removed. A charge is applied for this procedure.
NB - This procedure cannot be performed away from the DSE factory.
To Next Page
Loading...