Fault Finding
Page 85 of 90 057-233 ISSUE: 1
8.6 MISCELLANEOUS
NOTE: The above fault finding is provided as a guide check-list only. As the module can
be configured to provide a wide range of different features, always refer to the source of the
module configuration if in doubt.
Module appears to ‘revert’ to
an earlier configuration
When editing a configuration using the PC software it is vital that the
configuration is first ‘read’ from the controller before editing it. This
edited configuration must then be “written” back to the controller for
the changes to take effect.
When editing a configuration using the fascia editor, be sure to press
the Tick button to save the change before moving to another item
or exiting the fascia editor
To Next Page
Loading...