Front Panel Configuration
057-233 ISSUE: 1 Page 78 of 90
6.1.1 EDITING A PARAMETER
NOTE: The editor automatically exits after 5 minutes of inactivity to ensure security.
NOTE: The PIN number is automatically reset when the editor is exited (manually or
automatically) to ensure security.
NOTE: Refer to DSE335 Configuration Suite Manual (DSE part 057-237) for further details on
configuring, monitoring and control.
Enter the editor as described above.
Press the (left) or (right) buttons to cycle to the section to view/change.
Press the (up or down) buttons to select the parameter to view/change within the currently
selected section.
To edit the parameter, press the Tick
button to enter edit mode. The parameter begins to flash to
indicate that value is being edited.
Press the (up or down) buttons to change the parameter to the required value.
Press the Tick
button to save the value. The parameter ceases flashing to indicate that it has been
saved.
To exit the editor at any time, press and hold the Tick
To Next Page
Loading...