Connecting the to the charger
Connect the charger positive (11a) and
negative (9a) leads to the terminals: the red
one (11) to the positive terminal (+), the black one (9)
to the negative terminal (-).
Connect the plug of the charger to the wall
outlet.
Charge using the special Ducati-approved
charger (A) for lithium only.
Do not use chargers for lead or any
other type of maintainer/charger.
Charge the ensuring the vehicle is in a room
with a temperature below 40° C (104° F).
Keep the out of the reach of children.
Use only the Ducati-approved charger
(A) for lithium also as a maintainer.
Do not use the charge maintainer kit no.
69924601A (various countries) or charge
maintainer kit no. 69924601AX (for Japan, China and
Australia only), as it is specific for lead
NEVER connect the in parallel with
that of other vehicles, as this may cause a
circuit or overheating of the
To maintain the charge and use the Ducati-
approved charger, proceed as described in
the chapter “Maintaining the charge”.
When charging is complete, disconnect the
charger power cable from the wall outlet, remove the
black clip (9a) from the negative pole (-) and the red
clip (11a) from the positive pole (+).
Fig 189
244
To Next Page
Loading...
