Side stand
The position of the side stand is identified on
the instrument panel by the warning light. When the
warning light is on, the side stand is lowered (and the
engine is inhibited).
Place the motorcycle on the side stand only
when you are not going to use it for periods of
time. Before lowering the side stand, make sure that
the bearing is hard and flat.
Do not park on or pebbled ground or on asphalt
melted by the sun, etc. or else the motorcycle may
fall over. When parking downhill, always position the
motorcycle with the rear wheel facing downhill.
To pull down the side stand, hold the motorcycle
handlebar with both hands and push down on the
side stand (1) with your foot until it is fully extended.
Tilt the motorcycle until the side stand is resting on
the ground.
To easily find the side stand during the opening
phase, press on pin (3) with your foot.
STREET
11:34
A.M.
RPM X 1000
Gear
km/h
N
SETTING MENU
TRIP 1
0.0 km
TOT km
1245
0
SIDE
STAND
DWC 3
DTC 3
DSC 2
LO HI
A
Fig 29
Fig 30
52
To Next Page
Loading...
