When using the bike on the track, we
recommend removing the pin (3) by working on the
key (4).
To move the side stand to its rest position (horizontal
position), lean the motorcycle to the right while
the thrust arm (1) with your foot.
To ensure trouble-free operation of the side stand
joint, thoroughly clean it and then use SHELL
Alvania R3 grease to lubricate all friction points.
Do not sit on the motorcycle when it is
on the side stand.
Note
The engine can be with the side stand
down and the gearbox in neutral. If with a
gear engaged, pull in the clutch lever (in this case the
side stand must be up).
53
To Next Page
Loading...
