DRL in "Auto" mode – only for version with
DRL lights
If “DRL” lights were set to “Auto” via the “DRL”
function within the Menu (see page 203), the
instrument panel automatically manages the DRL
and the low beam according to detected ambient
light:
●
if the instrument panel detects good light
conditions (day) the DRL is turned on and the
low beam is turned
●
if the instrument panel detects poor light
conditions (night) the DRL is turned and the
low beam is turned on.
When DRL lights are set to AUTO mode, the display
shows the warning light (D).
If the DRL was set to "Auto" mode, press
(2, Fig 36) to disable that mode and set manual light
management. Press again (2, Fig 36) to re-
enable DRL but with control strategy set to
"Manual".
In this case, upon next Key-On, DRL will be again set
to "Auto" mode.
Using the DRL light in "Auto" mode in case of
poor light conditions, especially in case of fog or
clouds, could impair safety. In this case Ducati
recommends to manually activate the low beam.
0
11:34
A.M.
SPORT
Lap Off
RPM X 1000
Gear
km/h
N
DWC 3
DTC 3
DSC 2
SETTING MENU
TRIP 1
137.4 km
TOT km
1245
LO HI
HI
A
D
Fig 37
64
To Next Page
Loading...
