Duratech 2009 - Troubleshooting the Caterpillar C9 and C15 Tier III Engine and the Caterpillar C27 Tier II Engine

102
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
6.6 Troubleshooting the Caterpillar C9 and C15 Tier III engine and the
Caterpillar C27 Tier II engine
Connection A
One connector is used to connect the DuraTech wiring harness to the Caterpillar wiring.
If the Caterpillar engine requires troubleshooting, the DuraTech connection can be removed during the diagnosis. To
remove the DuraTech wiring for Caterpillar engine diagnoses disconnect connection A.
There is a 15 Amp fuse or circuit breaker in the Caterpillar wiring harness near the starter
( REV. 04-08 )