Duratech 2009 - Clutch System; Axle, Wheels and Tires

63
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
oil level indicator
(Ref # 4)
5.8 Axle, wheels and tires
TIRE PRESSURE
Set the tire pressure according to the manufacturer’s
specications. The appropriate tire pressure can be found on
the sidewall of the tire.
WHEEL BEARINGS
The wheels have tapered roller bearings in an oil
bath. Each hub is equipped with a transparent oil cap
which has an oil level indicator mark that allows for
easy checking of the oil level. The oil level should be
checked daily during the pre-operation inspection. This
lubrication method assures long bearing life with proper
maintenance of the oil level When adding or replacing
oil in the wheel bearings, use SAE 80W‑90 HYPOID
GEAR OIL.
AIR BRAKES
The air brakes should be inspected periodically by a qualied air brake technician.
5.7 Clutch system
Clutch is to be serviced and inspected after 5000 hours of operation ‑ contact your dealer for details.
( REV. 08-04 )
Check all HPTO bolted connections and hydraulic connections every 500 hours.
( REV. 08-04 )