Duratech 2009 - 2009 EL Electric Tub Grinder Operators Manual Supplement; Supplement Section 1: Start-Up (for S.N. up to 064)

107
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
2009EL Electric Tub Grinder Operators
Manual Supplement
This is a supplement to the 2009 Tub Grinder Operators Manual. The main part of this book applies to this Tub Grinder
except where described in this attached supplement.
Before Starting the 2009EL Electric Tub Grinder review all:
• Safety Recommendations – See Section 1 of this operator’s manual
• Pre‑Operation – See Section 3 of this operator’s manual
• Safetronics Instructional Manual – for all information regarding the soft start controller.
Supplement Section 1: Start-Up (For S.N. up to 064)
Warning: Make sure that all safety measures have been taken before switching on the power supply.
At Start up it is recommended that the rotor motor (labeled ‘ROTOR’) be started rst and then the hydraulics motor
(labeled ‘HYDRAULICS’). This will keep the amount of electricity used at initial startup down.
1. Before starting the 2009EL Electric Tub Grinder
make sure that “SS bypass” switch in the soft start
panel is set on “Off”.
2. Shout the word “CLEAR”.
Note: Bypass is to be used only if starter fails. Leave bypass “off” for normal operations. This is a
DIRECT LINE START! Current will be about 700% of full load amps.
Note: Next step will bring grinder up to full operating RPM
( REV. 10-13 )