113
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
Supplement Section 3: Lubrication
The Teco-Whitewestinghouse Motor that powers the rotor requires the use of Esso Polyrex Em or equivalent grease.
The (2) grease zerks on this motor must be re‑lubricated every 1000 hours. 270 grams of grease is to be placed in the
drive end zerk. 160 grams required for end opposite the drive. DO NOT OVER GREASE!
Locations of the grease zerks are shown below:
Drive end location (top of motor)Front location (top of motor)
zerk
zerk
( REV. 04-11 )
To Next Page
Loading...