34
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
3.13 Lowering the tub
To lower the tub, perform the following steps:
1. Remove the safety stop on the hydraulic cylinder, and place safety stop in storage location on the inside of
frame rail.
2. Clear the area of equipment and personnel.
3. Engine speed should be 1000 RPM.
4. Operate the tub tilt switch on the control panel to lower the tub.
3.14 Starting and stopping the belly and discharge conveyors
The belly and discharge conveyors are on one circuit, so one control starts and stops both conveyors. The control is
found at the operator panel near the engine. Conveyors should be started before the rotor is started, and should be
allowed to run until the rotor stops turning and all material is off the belts.
NOTE: See also section 3.16, “Operating the grinder using the remote radio option”
3.15 Lifting the discharge conveyor
The discharge conveyor can be raised or lowered as needed. There is one set of controls for raising and lowering the
conveyor located in the operator panel, and one set on the rear panel.
NOTE: See also section 3.16, “Operating the grinder using the remote radio option”
( REV. 08-04 )
( REV. 08-04 )
( REV. 08-04 )
To Next Page
Loading...