Duratech 2009 - Model 2009 El Electric Specifications

118
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
MODEL 2009EL ELECTRIC SPECIFICATIONS
General (Mobile Unit)
Weight
w/460 Volt Motor ......................................................................................30,520 lbs.
w/380 Volt Motor ......................................................................................31,620 lbs.
Transport Width ................................................................................................. 8’ 4”
Transport Height ............................................................................................. 10’ 10”
Transport Length ......................................................................................... 30’ 5”
Axles ............................................................................... Tandem Axles, 22,500 lbs.
Tires .........................................................................(4) 445/50R 22.5 Super Singles
Hydraulic Oil Capacity ..............................................................................50 gallons
Lights ................................................................... Clearance, Directional, and Brake
General (Skid Unit)
Weight
w/460 Volt Motor .................................................................29,020 lbs. approximate
w/380 Volt Motor .................................................................30,120 lbs. approximate
Transport Width ................................................................................................. 8’ 4”
Transport Height ............................................................................................. 10’ 10”
Transport Length ......................................................................................... 26’ 6”
Tub features
Tub Width .................................................................................................... 9’ 6‑3/8”
Depth .................................................................................................................... 40”
Tub Diameter At Base ........................................................................................ 7’ 6”
Tub Wall ................................................................................................... 3/16” thick
Tub Floor ..................................................................................... 1/4” thick AR Steel
Tub Drive ................................................................................ Hydraulic orbit motor
Discharge Conveyor ............................................21’ 6” Long Top drive X 24” Wide
Belly Conveyor ........................................................................................... 30” Wide
Tub Speed Sensor ............................................................................ Magnetic Sensor
Hammermill
Rotor ‑ Shaft Diameter ........................................................ 4‑1/2” stress proof steel
Rotor Length ........................................................................................................ 40”
Rotor Plates ..........................................................................16” diameter x 1” thick
Feed Opening ............................................................................................ 45” x 25”
Screen Area ............................................................................................ 2,240 sq. ft.
Hammer Rods ............................................................................. (8) 1‑1/2” diameter
Bearings .......................................................................... 3 1/2” Pillow block bearing