112
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
Supplement Section 2: Shut-Down Procedure (For SN 065 and up)
1. Run the 2009EL Electric Tub Grinder until discharge conveyor is empty, and grind as much of the
material in the tub as possible.
2. Push the stop button for the rotor motor. The button is located on the control panel marked ‘ROTOR’.
( REV. 09-17 )
Stop button ROTOR
3. Then press the stop button for the electrical motor that runs the hydraulic pump. This can be found on the
control panel marked ‘HYDRAULICS’.
Stop button HYDRAULICS
‘EMERGENCY STOP’ shuts off both motors at the same time. Only use if it is an emergency.
To Next Page
Loading...