Duratech 2009 - Adjusting Tub Chain Tension; Engaging Clutch; Disengaging the Clutch

45
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
3.32 Engaging clutch
IMPORTANT: Read and have a thorough understanding of the clutch operators manual.
IMPORTANT: Never engage the clutch when platform is raised.
3.31 Adjusting tub chain tension
To adjust the tub chain tension, perform the following steps:
1. Loosen (4) bolts holding motor mounting
plate.
2. Turn (2) adjusting bolts to set chain tension.
3. Tighten the (4) bolts holding motor mounting
plate.
adjusting bolts
lock bolts
chain path
To engage the clutch, perform the following steps:
1. Before starting engine, the rotor box should be cleared of all material.
2. Start the engine. Engine must be at 800‑1100 rpm; the controller will not engage the clutch when engine
speed is above 1100 rpm. The “POWER” LED and the “ENGINE RPM” LED will be illuminated.
3. Push the Clutch Start Button in for about 3 seconds. When the “CLUTCH ENGAGED” symbol
illuminates, the Start Button can be released.
3.33 Disengaging the clutch
To disengage the clutch:
1. Empty the tub.
2. Reduce engine speed to below 1200 rpm.
3. Push the Clutch Start Button for 1 second. The clutch will disengage, and the “CLUTCH ENGAGED”
symbol will not be illuminated.
( REV. 08-04 )
( REV. 08-04 )
( REV. 08-04 )