iv
2009 DURATECH TUB GRINDER OPERATING INSTRUCTIONS
TABLE OF CONTENTS
5.11 Rotor bearing maintenance ........................................................................ 68
5.12 Dodge Rotor bearing installation (SN 065 & up) ......................................... 69
5.13 Hammermill maintenance ............................................................................. 73
5.14 Fixed hammer maintenance and replacement ............................................... 74
5.15 Swinging hammer replacement and maintenance ......................................... 75
Section 6: Troubleshooting the 2009 DURATECH TUB GRINDER 80
6.1 Troubleshooting the electronic governor system ............................................ 80
6.2 Electro-hydraulic valve calibration (for S.N. Up to 20-4-DJ0019) ................. 86
6.2a Electro-hydraulic valve calibration (for S.N. 20-2-GJ0020 and up) .... 87
6.3 General Troubleshooting ................................................................................. 88
6.4 Troubleshooting Omnex Wireless Remote Controls ....................................... 89
6.5 Troubleshooting Omnex Wireless 10 Button Remote Control ........................ 92
6.6 Troubleshooting the Caterpillar C9 and C15 Tier III engine and the Caterpillar
C27 Tier II engine ......................................................................................... 102
Appendix A: Warranty .............................................................. 103
Appendix B: SPECIFICATIONS ................................................. 104
2009EL Electric Tub Grinder Operators Manual Supplement . 107
Supplement Section 1: Start-Up (For S.N. up to 064) ........................................ 107
Supplement Section 1: Start up (For SN 065 and up) ......................................... 109
Supplement Section 2: Shut-Down Procedure (For S.N. up to 064) ....................111
Supplement Section 2: Shut-Down Procedure (For SN 065 and up) .................. 112
Supplement Section 3: Lubrication ..................................................................... 113
Supplement Section 4: Raising/lowering the tub platform, raising/lowering the
discharge conveyor, and folding/unfolding the discharge conveyor. ................... 114
Supplement Section 5: Hydraulic cooler ............................................................. 115
Supplement Section 6: Control Panel .................................................................. 116
Supplement Section 7: Belt Deection ............................................................... 117
MODEL 2009EL ELECTRIC SPECIFICATIONS .......................... 118
Appendix C: Operator Training Form ....................................... 121
2009 DURATECH TUB GRINDER Documentation Comment Form . 123
To Next Page
Loading...