6.1.3.3 DC1550/DA321G drive
Parameter change for machines w ith gear rate of 28/28 teeth
Parameter Original value New value Parameter description
290* 0 3 Class of the machine
111 - - Max. sewing speed
170 - - Reference position
Parameter change for machines w ith gear rate 18/28 teeth
Parameter Original value New value Parameter description
290* 0 4 Class of the machine
111 - - Max. sewing speed
170 - - Reference position
* The parameter must be entered first.
Attention:
To set up parameters higher than 200, it is necessary to enter the
control in the programmer ’s level (via 3312 code). This allows also
entering parameters lower than 200.
22
To Next Page
Loading...
