36 / 84 SM-SG-2 Ev3/25062014
6.8 REPLACEMENT OF THE BLADE DRIVING BELT SPB 2410
- Lift the mower up to the max. height of cut and tilt it to the side of the fuel tank!
Dismounting:
- Remove mowing blades, carrier cartridges, nylon bearing covers, clutch cover and belt covers (Fig.s 62, 63,
64)
- Release a tensioning bearing box screws (Fig. 68)
- By turning of the belt tensioner (Fig. 68) release the belt
- Remove the belt SPB 2410 see 6.8 Replacement of the blade driving belt SPB 2410
Mounting: (Take the above steps in reverse order)
- Install the blade driving belt SPB 2410 (Fig. 67)
- Tension the belt SPB 2410 by means of the tensioning bearing box and belt ttensioner (Fig. 68)
- Loctite the bolts of the tensioning bearing box (LOCTITE 243)
- Install the belt covers and Loctite the belt cover bolts
- Install the clutch cover. Secure the screws with LOCTITE 243
- Install the nylon bearing covers, the blade carrier cartridges (don´t forget the keys), using grease for easier
next manipulation
- Install the blades, Loctite the bolts (LOCTITE 243) and torque to 60 Nm
Fig. 67 Fig. 68
To Next Page
Loading...
