44 / 84 SM-SG-2 Ev3/25062014
After the aplication let´s it penetrate for 25 minutes then blow the rest out with pressurized air
- Check the wheel geometry see 6.23 Adjustment of the wheel geometry
6.14 REPLACEMENT OF THE STEERING MOTOR
Dismounting:
- Lift the mower so that the wheels must be off the ground and can turn freely
- Disconnect the battery
- Disconnect the supply cables of the electric servomotor (Fig. 85) and cable ties
- Release the driving chain
- Disconnect the chain and remove it from the motor sprocket
- Undo the set bolt and the bolt M10 and replace the motor (Fig. 86)
- Note the correct sequence of the tensioning pulleys and their distance rollers
Fig. 85
Fig. 86
Mounting:
- Install the new steering motor - set (Fig. 87)
- Check the position of the chain and pulleys
- Tension the chain (the chain slack on side of the steering electric motor should be 20 mm) by rotating the
servomotor and tightening the set bolt and the bolt M10 (Fig. 82)
- Lubricate the chain with a chain lubrication spray Interflon FIN LUBE TF
- Check the wheel geometry see 6.23 Adjustment of the wheel geometry
Fig. 87
To Next Page
Loading...
