EasyManuals Logo

DynaGen GSC400 Series User Manual

DynaGen GSC400 Series
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30 of 105
The controller can be made to NOT sound the alarm when the controller is not in the
AUTO mode. This is controlled by the Not In Auto setting.
The OFF Mode Start setting can be set to Enable to allow a manual start from the OFF
mode. Otherwise a manual run can only be performed when the controller is in the
AUTO mode.
Table 5 – Basic Setup Menu
Menu SELECTION AND RANGE
Contrast Adjust 5-95 %
Page Roll Delay 1-10 s
State Roll Delay 1-10 (1 is shortest delay, 10 is longest)
Sleep Delay 10-600s. Shorter is ideal to extend the
backlighting life.
Maintenance Read only. Displays the amount of hours until
next service if this feature is enabled. If service
is overdue the hours become negative.
Not In Auto Disable Beep, Enable Beep
OFF Mode Start Disable, Enable

Table of Contents

Other manuals for DynaGen GSC400 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DynaGen GSC400 Series and is the answer not in the manual?

DynaGen GSC400 Series Specifications

General IconGeneral
BrandDynaGen
ModelGSC400 Series
CategoryController
LanguageEnglish

Related product manuals