EasyManuals Logo

DynaGen GSC400 Series User Manual

DynaGen GSC400 Series
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
70 of 105
6.10 Password Setup
The GSC400 allows a 4 digit password
to be entered to protect the advanced
setup menu from any unauthorized
changes. This password will be needed
to perform any changes to the
advanced setup. If the password is
entered incorrectly, the controller will
allow 3 more tries before the GSC400
returns back to the main menu.
To set each digit of the password, do
the following:
Select Password No.1 (Digit 1)
Enter the desired number 0-9
Select Password No.2 (Digit 2)
Enter the desired number 0-9
Select Password No.3 (Digit 3)
Enter the desired number 0-9
Select Password No.4 (Digit 4)
Enter the desired number 0-9
Remember to write down the password
for future reference. The default
password is all zeros.
You can only reset the password using
the GSC400 PC Interface. To reset the
passwords click on “Load Factory
Defaults” under File in the top menu.
This will reset ALL settings to their
factory default so make sure to record
the controller settings before doing this.

Table of Contents

Other manuals for DynaGen GSC400 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DynaGen GSC400 Series and is the answer not in the manual?

DynaGen GSC400 Series Specifications

General IconGeneral
BrandDynaGen
ModelGSC400 Series
CategoryController
LanguageEnglish

Related product manuals