7 of 105
1 GSC400 Controller Series
The GSC400 is designed for use on
generator sets with either mechanical or
electronic (J1939) engines. It can monitor
analog data from senders on the engine
and generator such as oil pressure, coolant
temperature, current, voltage, and engine
speed and generator frequency. The
GSC400 can also gather engine p
from the engine ECM via J1939 and u
them to control the engine or for display
purposes.
GSC400 Front View
GSC400 Back View
arameters
se
r
85
An RS232 interface is provided that
allows communication with the DynaGen
GSC400 PC Interface to change settings o
display information on the PC. An RS4
port is provided for Modbus
communications (slave only) for remote
annunciation or communications.
In addition to the monitoring features, the
GSC400 controller can be used to
automatically start/stop a generator system
as well as provide protective warnings or
shutdowns.
1.1 This Manual
This manual is divided into three sections:
1. Hardware installation
2. Operation / configuration
3. Advanced configuration
To Next Page
Loading...
