Eaton 9355 Series - Figure 3. Removing the Brackets and Shipping Pad

Eaton 9355 Parallel UPS (10/15 kVA) User's Guide 164201601—Rev E0 15
Figure 3. Removing the Brackets and Shipping Pad
Stabilizing Bracket
Front Shipping
Bracket
Shipping Pad
M4 Screws
M10 Bolts
M10 Bolts
Pallet Bracket (x2)
(Secures the rear UPS
leveling feet to the pallet)
7. Reinstall the front cover removed in Step 4.
Hang the top edge of the cover on the cabinet first, then lower the bottom edge and snap into place.
NOTE Support the front and back of the cabinet when rolling it off the pallet to prevent tipping.
8. Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts, continue rolling the cabinet down
the pallet until the cabinet touches the floor (see Figure 4).
If needed, adjust the leveling feet so that the cabinet rolls freely.
UPS System Installation