Eaton 9355 Series - Figure 6. Removing the Vertical Bracket

Eaton 9355 Parallel UPS (10/15 kVA) User's Guide 164201601—Rev E0 17
Figure 6. Removing the Vertical Bracket
M10 Bolt
M4 Screws
3. Reinstall the M4 screws to the UPS (see Figure 7).
Figure 7. Reinstalling the M4 Screws and Remove Pallet Brackets
M4 Screws
Pallet Bracket (x2)
(Secures the rear UPS
leveling feet to the pallet)
4. Remove the M10 bolts from the two Pallet Brackets securing the leveling feet to the pallet (see Figure 7
5. Repeat Step 1 through Step 4 to remove the vertical bracket on the other side.
6. Remove the front cover from the bottom cabinet to access the front shipping bracket.
Press and release the handle latch at the bottom of the cover and then lift the cover up and off the cabinet.
7. Remove the three M10 bolts securing the rear shipping pad to the pallet and remove the shipping pad (see
Figure 8).
NOTE Hold the back of the cabinet so that the bolts can be removed easily without the cabinet
rolling backward.
UPS System Installation