Eaton 9355 Series - Figure 8. Removing the Front Shipping Bracket and Shipping Pad

18 Eaton 9355 Parallel UPS (10/15 kVA) User's Guide 164201601—Rev E0
8. Remove the two M10 bolts securing the front shipping bracket and remove the bracket.
If needed, adjust the leveling feet to release the bracket.
Figure 8. Removing the Front Shipping Bracket and Shipping Pad
Front Shipping
Bracket
Shipping Pad
M10 Bolts
M10 Bolts
9. Reinstall the front cover removed in Step 6.
Hang the top edge of the cover on the cabinet first, then lower the bottom edge and snap into place.
NOTE Support the front and back of the cabinet when rolling it off the pallet to prevent tipping.
10. Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts, continue rolling the cabinet down
the pallet until the cabinet touches the floor (see Figure 9).
If needed, adjust the leveling feet so that the cabinet rolls freely.
UPS System Installation