Eaton 93PR 60-1200 kW UPS
Installation and Operation Manual
113
Copyright © 2021 Eaton Corporation plc. All rights reserved.
module will not build a power supply and enter the parallel system until you have completed
the above four steps and press the ESC key on the LCD panel the cold start button.
9. UPM installation is complete.
Reducing/Replacing the UPS Module Online
1. Set the position lock located on the front panel of the module to “ ”. Two people each hold
the handles located on the front panel of the UPS module with one of their hands and support
the bottom of the module with the other hand respectively and they both use their strength
together to draw the module outward smoothly and slowly until it is out, and then support it
together and put it on the ground or some other temporary supports gently.
2. To replace UPM, please implement removing UPM steps and then do adding UPM steps.
WARNING
Ensure the lock has to unlock the state, when pull out the UPM.
Position Lock
1
1
1
1
2
2
Figure 6-42: UPM Module Location
To Next Page
Loading...
