Eaton 93PR - Chapter 11 APPENDIX A: USER SETTINGS; Table 11-1: User Settings; Table 11-2: Config Settings

Eaton 93PR 60-1200 kW UPS
Installation and Operation Manual
129
Copyright © 2021 Eaton Corporation plc. All rights reserved.
Chapter 11 APPENDIX A: USER SETTINGS
The UPS has the following settings that are user modiable. In the Home screen, select Settings. User settings:
Table 11-1: User Settings
To modify the Cong settings, you need to sign in.
Setting Description
Info
Information on the UPS model, including part number and
serial number.
About Version information.
Clear Status Reset system Status.
Clear Alarms Reset Sticky Alarms.
Table 11-2: Cong Settings
Setting Description
Language
Change the user interface language.
Unit Name
Change the unit name.
Clock
Change the date and time, change the clock for-mat or
enable/disable NTP clock setup.
Signal Inputs
Select signal input name and function.
Relay Outputs
Congure the relay outputs.
Battery Test
Change the power level and duration for battery test.
Bypass Limits
Change bypass voltage, bypass frequency or by-pass slew
rate limits.
Screen Saver Timeout
Change the screen saver timeout.
Meters
Change the meters format.
Lamp Test
Enable the lamp test.
HMI backlight
Adjust the backlight brightness.
Control P/W level 1
Change the level 1 password, or remove the password on
level 1. The default value is 1111.
Cong P/W level 2
Change the level 2 password. The default value is 0101.