Less than 1"
(25.4 mm)
Slowly let up on the pedal and
measure the pedal position at the
moment the gauge can be removed:
• If pedal is more than 1" (25.4 mm)
from the floor, readjust the truck
linkage to move the yoke fingers
further from the release bearing.
Return to Step 4.
5
Have an assistant insert 0.010"
(0.25 mm) feeler gauge between
the release bearing and the
clutch brake.
Press the pedal down to the floor
to reclamp the gauge:
• If the gauge does not clamp,
readjust the truck linkage and
move yoke fingers closer to
the bearing.
Use a gauge long enough to keep
hands away from movi
ng parts.
4
WARNING
Release
Bearing
Yoke
Finger
Clutch
Brake
DO NOT RESET THE CLUTCH. Do not change
free-play by readjusting the clutch linkage.
Verify there is free-play in the cab. If not, the
truck linkage is not providing enough stroke,
consult OEM manual for free-play dimension.
For Solo clutches, proceed to Step 8. For Solo
Advantage clutches, proceed to Step 9.
6
IMPORTANT
To Next Page
Loading...
