Input
Shaft
Zerk
Input Shaft
Note: All clutches use a Lithium
complex grease with a minimum
of 325°F (163°C) operating range
meeting NLGI grade 2 or 3 specs.
For additional lubrication
information, see TCMT0021.
Apply grease to input shaft
and yoke fingers.
2
8
Failure to properly lubricate the
bearing/bushing will result in
bearing and sleeve failures.
CAUTION
IMPORTANT
7
Apply ample grease that is visibly
exiting the opening and contacts
the transmission shaft. This will
lube the clutch brake and bushing
when the pedal is pressed.
Apply grease to the cross
shaft bushings and linkage
pivot points.
9
Do not add lube (never seize or
grease) to the input shaft splines.
The disc must be free to move.
To Next Page
Loading...
