Eaton ePDU G3 - Saving and Loading Hardware Configuration

LCD Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 5 53
Table 7 shows which measures will be present:
Total Input Meter Data
On the Meter menu, scroll up or down to highlight ePDU. Press ENTER to display the Total Input submenu for
your 1Ph, 3Ph, split-phase, or dual input ePDU. Press ENTER again to see Total Input meter data
measurements. Scroll up or down to review other Total Input meter data measurements. After you review the
data, you can press ESC to return to the Input Meter menu and select L1, L2, or L3 to see Phase Input
measurements. Press ESC to return to the previous menu.
For example, Figure 52 shows a total input display for 1Ph ePDUs.
Figure 52. Example 1Ph Total Input Display
Table 7. Measures for Total Input and Phase Input Meter Screens
Measure Total Input Wye-wired Input Phase Delta-wired Input Phase
Frequency • — —
Voltage — • •
Current — • •
Percent Load — • •
Active Power • • —
Crest Factor — • •
Apparent Power • — —
Reactive Power • — —
Power Factor • — —
Energy • — —
Peak Power • — —
NOTE The Total Input > Input Meter selection screens will be different for 1Ph, 3Ph, dual
input, and split-phase ePDUs.
Down
Down
Down
Enter
Total Input
Total Input
ePDU Meter
Frequency
50.23 Hz
Active Power
100 W
Apparent Power
120 VA
Reactive Power
20 VAR
Power Factor
0.912
Energy
16.238 kWh
since
07/01/2011
17:32:23
Peak Power of
xxxx W
since
07/01/2011
17:32:23
ESC
Enter
ESC
Total Input Meter
ePDU
Sections
Outlets
Environment
Meter
Total Input Meter
Total Input MeterTotal Input Meter
Total Input Meter