Eaton PowerXL DA1 - Page 139

4 Operation
4.4 Handling the keypad
DA1 Variable Frequency Drives 11/16 MN04020005Z-EN www.eaton.com 135
Table 19: Keypad elements – Buttons
Button Attribute ID
Explanation
OK • Navigating in parameter mode
• Opens and closes the parameter interface
(press the button and hold it down for more than two seconds)
• Saves parameter changes
• Changes the value being displayed: A, rpm, etc. (real-time
information)
START
• Starts the variable frequency drive
1)
• Changes the operating direction
2)
if the motor is running
STOP • Stops the variable frequency drive
1)
• Reset – Resetting after fault message
UP • Increases the speed
1)
• Increment numeric value or parameter number
DOWN • Decreases the speed
1)
• Decrement numeric value or parameter number
Note:
1) P1-12 = 1 (one operating direction) or P1-12 = 2 (two operating directions);
The operating direction will be reversed when the START button is pressed
2) P1-12 = 2 only