Eaton XV300 Series - Page 29

2. Safety instructions
2.3 Device-specific hazards
likely to occur.
Remove the SD card only when the XV300 is de-energized.
Before switching off the device, make sure that there are no programs writing
to the SD card.
CAUTION
SHORT-CIRCUITHAZARD
IftheXV300TouchPanelisorhasbeenexposedtoenvironmentalfluc-
tuations(ambienttemperature,airhumidity),condensationmayformonor
insideit.Aslongasthiscondensationispresent,therewillbeashort-circuit
hazard.
DonotswitchontheXV300TouchPanelwhenithascondensationinoron
it.
IftheXV300hascondensationinoronit,orifthepanelhasbeenexposed
toenvironmentalfluctuations,letthepanelsettleintotheexistingambient
temperaturebeforeswitchingiton.DonotexposetheXV300TouchPanel
todirectthermalradiationfromheatingappliances.
CAUTION
UVLIGHT
PlasticswillbecomebrittlewhenexposedtoUVlight.Thisartificialaging
willreducetheXV300unit'slifespan.ProtecttheXV300unitfromdirectsun-
lightandothersourcesofUVradiation.
CAUTION
POINTY,SHARPOBJECTSANDCORROSIVELIQUIDS
WhencleaningtheXV300:
l Do not use any pointy or sharp objects (e.g., knives).
l Do not use aggressive or abrasive cleaning products or solvents.
MakesurethatnoliquidsgetintotheXV300unit(short-circuithazard)and
thattheXV300unitisnotdamagedinanyway.
CAUTION
INSTALLATIONCUT-OUT
Themountingcutoutmustbelocatedinapositionthatwillnotdefeatthe
purposeofstabilizingwebsorotherreinforcingelementsinthecontrol
panel.Ifnecessary,reinforcingelementsmustbeinstalled/added.
AnIP65,Nema4xorNema12degreeofprotectionwillonlybeensuredif
thereissufficientstiffness,thedeviceisproperlymountedusingtheoriginal
fixingmaterial,andthegaskethasaproperseat
l Minimum sheet thickness of control panel panel where the device will be flush
mounted:
2 mm (0.08") ≦ d ≦ 5 mm (0.2")
CAUTION
Whenusingcommerciallyavailableperipheraldevices(e.g.,withtheUSB
port),itisimportanttokeepinmindthattheirEMCinterferenceimmunity
parametersmayrenderthemunsuitableforuseinindustrialenvironments.
TheUSBports(USBhostandUSBdevice)ontheXV300TouchPanelunit
aremeantformaintenanceworkonly.
XV30012/15 MN048017 ENwww.eaton.eu
29