UMSCHALTNG
POS: XXXXX
Input Default
Um AUS TT-TT
hh:mm
End time of the changeover to the alternative setpoint set;
weekday from-to TT-TT, time hh:mm; only displayed for active internal toggle
setpoint (menu 3-3)
, , (Mon-Sun etc.) or
numbers (hh:mm)
Sun
9:00
PM
... A total of 14 different ON, OFF toggle times can be recorded.
A toggle time is only observed if an of switch-on and switch-off
associated pair
time is parametrised.
9.1.5 Menu 4 Messages
MELDUNGEN POS:
XXXXX
1 view Continue to menu 4-1 Display log memory
2 acknowledge The messages in the log memory are acknowledged; alarms acknowledged according to display: back using ESC
3 delete Continue to menu 4-3 Delete log memory (with confirmation)
Menu 4-1 Messages Display
MELDUNGEN POS: XXXXX
Error text 1: Error text of fault 1
dd/mm/yy hh:mm ON Start of the fault 1
dd/mm/yy hh:mm OFF End of the fault 1 (only if fault 1 is ended)
...
Error text n: Error text of fault n
dd/mm/yy hh:mm ON Start of the fault n
dd/mm/yy hh:mm OFF End of the fault n (only if fault n is ended)
Menu 4-2 Acknowledge Messages
Message is shown on the display.
Alarms acknowledged!
Menu 4-3 Delete Messages
MELDUNGEN POS: XXXXX Input
Delete!
Are you sure?
No: ESC
Yes:
Confirmation prompt for deletion of messages,
after acknowledgement display::
back with ESC
, ESC
9.1.6 Menu 5 Archive
ARCHIV POS: XXXXX
dd/mm/yy hh:mm Time of the archiving of data set 1
Zone 1: abcdefx °C Status and temperature of Zone 1, see remark *)
Zone 2: abcdefx °C Status and temperature of Zone 2, see remark *)
...
dd/mm/yy hh:mm Time of the archiving of data set n
Zone 1: abcdefx °C Status and temperature of Zone 1, see remark *)
Zone 2: abcdefx °C Status and temperature of Zone 2, see remark *)
To Next Page
Loading...
