EDAN DUS 60 - Presetting Data; Presetting DICOM; Maintenance; Printing

DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual System Control
- 54 -
4. Roll the trackball to highlight the right side frame of User-defined, and press Set. Then the
cursor turns to “׀”, as shown below. You can enter some detailed help information about the
new created comment with the keyboard.
Figure 5-23 User-defined Detailed Information of Comment Library
5. Roll the trackball to highlight Add to add the new created comment to Generic.
6. Press OK to save the modification, or press Cancel to give up and close the dialog box.
To delete text from text list:
1. Press Generic to open the Generic.
2. Roll the trackball to highlight the created comment, and press Set.
3. Press Del to delete the created comment.
4. Press OK to save the modification, or press Cancel to give up and close the dialog box.
5.7.8. Presetting Data
The secondary menu of preset data is shown below:
You can use this option to return to the factory default data.
5.7.9. Presetting DICOM
If you have installed the DICOM software, perform the DICOM presetting as shown below.
Figure 5-24 DICOM Presetting
DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual System Control
- 55 -
Item Description
System AE Title
The same as the title set in the AE Title of Local
Institution Name Set the name of the institution
AE Title Set the local AE title
Host Name Set the local host name
IP Address Set the local IP address
Port Set the local port
Alias Set the alias of the local system
Local
Package
Size
Set the PDU transmission package size, from 4K to 64K, and the
default value is 16K.
AE Title
Set the server AE title, the same as the System AE Title displays
Host Name Set the server host name
IP Address Set the server IP address
Port Set the server port
Alias Set the alias of the server
Server 1/2
Package
Size
Set the PDU receiving package size, from 4K to 64K, and the
default value is 16K.
Verify
After presetting the server information, press Verify to verify the server’s
connection.
Current Server To choose the current server that is connected to the system.
Table 5-10 DICOM Presetting Information
Press OK to save the presetting and exit, or Cancel to exit without saving the presetting.
NOTE:
1. Do not set a same IP Address for the local system and the server.
2. Ensure that you have turned on the server before verifying it.
5.7.10. Maintenance
The maintenance can be only done by EDAN authorized personnel.
5.8. Printing
To connect a video printer:
1. Connect VIDEO IN (video input) of the video printer to VIDEO OUT (video output) of the
main unit.
2. Connect REMOTE of the video printer to REMOTE of the main unit.