Chapter 50
| IP Routing Commands
Policy-based Routing for BGP
– 1154 –
continue Goes to a route-map entry with a higher sequence number
after a successful match occurs
RM
description Creates a description of an entry in the route map RM
match as-path Sets an AS path access list to match RM
match community Sets a BGP community access list to match RM
match extcommunity Sets a BGP extended community access list to match RM
match ip address Specifies destination addresses to match in a standard
access list, extended access list, or prefix list
RM
match ip next-hop Specifies next hop addresses to match in a standard access
list, extended access list, or prefix list
RM
match ip route-source Specifies the source of routing messages to match in a
standard access list, extended access list, or prefix list
RM
match metric Sets the metric value to match in routing messages RM
match origin Sets the originating protocol to match in routing messages RM
match pathlimit as Sets the maximum AS path length for propagation of more
specific prefixes to match in routing messages
RM
match peer Sets the peer address to match in routing messages RM
on-match Sets the next entry to go to when this entry matches RM
set aggregator as Assigns an AS number and IP address to the aggregator
attribute of a route
RM
set as-path Modifies the AS path by prepending or excluding an AS
number
RM
set atomic-aggregate Indicates the loss of some information in the route
aggregation process
RM
set comm-list delete Removes communities from the community attribute of
inbound or outbound routing messages
RM
set community Sets the community attributes of routing messages RM
set extcommunity Sets the extended community attributes of routing
messages
RM
set ip next-hop Sets the next-hop for a routing message RM
set local-preference Sets the priority within the local AS for a routing message RM
set metric Sets the metric value of a route to external neighbors RM
set origin Sets the origin code for the routing protocol which
generated this message
RM
set originator-id Sets the IP address of the routing message’s originator RM
set pathlimit ttl Sets the maximum AS path length for propagation of more
specific prefixes in routing messages
RM
set weight Sets the weight for routing messages RM
show route-map Shows the configuration setting for a route map PE
Table 29: Policy-based Routing Configuration Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General