Chapter 8
| Authentication Commands
AAA
– 261 –
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
â—† This command runs accounting for Exec service requests for the local console
and Telnet connections.
â—† Note that the default and method-name fields are only used to describe the
accounting method(s) configured on the specified RADIUS or TACACS+ servers,
and do not actually send any information to the servers about the methods to
use.
Example
Console(config)#aaa accounting exec default start-stop group tacacs+
Console(config)#
aaa accounting
update
This command enables the sending of periodic updates to the accounting server.
Use the no form to disable accounting updates.
Syntax
aaa accounting update [periodic interval]
no aaa accounting update
interval - Sends an interim accounting record to the server at this interval.
(Range: 1-2147483647 minutes)
Default Setting
1 minute
Command Mode
Global Configuration
Command Usage
â—† When accounting updates are enabled, the switch issues periodic interim
accounting records for all users on the system.
â—† Using the command without specifying an interim interval enables updates,
but does not change the current interval setting.
To Next Page
Loading...
Need help?
General