Chapter 8
| Authentication Commands
AAA
– 262 –
Example
Console(config)#aaa accounting update periodic 30
Console(config)#
aaa authorization exec This command enables the authorization for Exec access. Use the no form to
disable the authorization service.
Syntax
aaa authorization exec {default | method-name}
group {tacacs+ | server-group}
no aaa authorization exec {default | method-name}
default - Specifies the default authorization method for Exec access.
method-name - Specifies an authorization method for Exec access.
(Range: 1-64 characters)
group - Specifies the server group to use.
tacacs+ - Specifies all TACACS+ hosts configured with the tacacs-server
host command.
server-group - Specifies the name of a server group configured with the
aaa group server command. (Range: 1-64 characters)
Default Setting
Authorization is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
â—† This command performs authorization to determine if a user is allowed to run
an Exec shell for local console, Telnet, or SSH connections.
â—† AAA authentication must be enabled before authorization is enabled.
â—† If this command is issued without a specified named method, the default
method list is applied to all interfaces or lines (where this authorization type
applies), except those that have a named method explicitly defined.
Example
Console(config)#aaa authorization exec default group tacacs+
Console(config)#
To Next Page
Loading...
Need help?
General