Chapter 8
| Authentication Commands
Web Server
– 270 –
Command Usage
â—† You cannot configure the HTTP and HTTPS servers to use the same port.
â—† If you change the HTTPS port number, clients attempting to connect to the
HTTPS server must specify the port number in the URL, in this format: https://
device:port_number
Example
Console(config)#ip http secure-port 1000
Console(config)#
Related Commands
ip http secure-server (270)
show system (134)
ip http secure-server This command enables the secure hypertext transfer protocol (HTTPS) over the
Secure Socket Layer (SSL), providing secure access (i.e., an encrypted connection)
to the switch’s web interface. Use the no form to disable this function.
Syntax
[no] ip http secure-server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
â—† Both HTTP and HTTPS service can be enabled independently on the switch.
However, you cannot configure the HTTP and HTTPS servers to use the same
UDP port.
â—† If you enable HTTPS, you must indicate this in the URL that you specify in your
browser: https://device[:port_number]
â—† When you start HTTPS, the connection is established in this way:
â–
The client authenticates the server using the server’s digital certificate.
â–
The client and server negotiate a set of security protocols to use for the
connection.
â–
The client and server generate session keys for encrypting and decrypting
data.
â—† The client and server establish a secure encrypted connection.
To Next Page
Loading...
Need help?
General