Chapter 10
| Access Control Lists
IPv6 ACLs
– 409 –
Command Usage
If a port is already bound to an ACL and you bind it to a different ACL, the switch
will replace the old binding with the new one.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#
Related Commands
show ipv6 access-list (409)
Time Range (189)
show ipv6
access-group
This command shows the ports assigned to IPv6 ACLs.
Command Mode
Privileged Exec
Example
Console#show ipv6 access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Global
IPv6 standard access-list david in
Console#
Related Commands
ipv6 access-group (Interface Configuration) (408)
show ipv6 access-list This command displays the rules for configured IPv6 ACLs.
Syntax
show ipv6 access-list {standard | extended} [acl-name]
standard – Specifies a standard IPv6 ACL.
extended – Specifies an extended IPv6 ACL.
acl-name – Name of the ACL. (Maximum length: 32 characters)
Command Mode
Privileged Exec
Example
Console#show ipv6 access-list standard
IPv6 standard access-list david:
permit host 2009:DB9:2229::79
To Next Page
Loading...
Need help?
General