Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 757 –
mvr6 vlan This command specifies the VLAN through which MVR6 multicast data is received.
Use the no form of this command to restore the default MVR6 VLAN.
Syntax
mvr6 domain domain-id vlan vlan-id
no mvr6 domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR6 multicast data is received.
This is also the VLAN to which all source ports must be assigned.
(Range: 1-4094)
Default Setting
VLAN 1
Command Mode
Global Configuration
Command Usage
MVR6 source ports can be configured as members of the MVR6 VLAN using the
switchport allowed vlan command and switchport native vlan command, but
MVR6 receiver ports should not be statically configured as members of this VLAN.
Example
The following example sets the MVR6 VLAN to VLAN 1:
Console(config)#mvr6 domain 1 vlan 1
Console(config)#
mvr6 immediate-leave This command causes the switch to immediately remove an interface from a
multicast stream as soon as it receives a leave message for that group. Use the no
form to restore the default settings.
Syntax
[no] mvr6 domain domain-id immediate-leave [by-host-ip]
domain-id - An independent multicast domain. (Range: 1-5)
by-host-ip - Specifies that the member port will be deleted only when
there are no hosts joining this group.
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
To Next Page
Loading...
Need help?
General